Trailer Parts | etrailer.com (2024)

Products
Videos
Articles
Questions

Popular Categories

Hub-and-drum assembly for your trailer. For electric or hydraulic brakes. Fits 3.5K Dexter E-Z Lube and etrailer Easy Grease axles. Inner bearing (L68149) and race, outer bearing (L44649) and race, grease seal, grease cap, and lug nuts included.

• 5 on 4-1/2 Inch
• For 3500 lbs Axles
• Hub with Integrated Drum
• 13 Inch Wheel
• 14 Inch Wheel
• 14-1/2 Inch Wheel
• 15 Inch Wheel
• Easy Grease
• EZ Lube
• Pre-Greased
• L44649
• L68149
• etrailer

Boat Trailer Roller Bunk Bracket for Dutton-Lainson Roller Bunks

• Bunks
• Rollers
• Roller Bunk Bracket
• Dutton-Lainson

Contains everything needed to repack one hub on your Lippert, Dexter, or AL-KO 3,500-lb axle.

• Race L68111 and L44610
• Bearing L44649 and L68149
• Bearings
• 3500 lbs Axle
• Standard Bearings
• Bearing Kits
• etrailer

Dutton-Lainson roller bunk bracket for boat trailers.

• 10-3/4 Inch Long
• Bunks
• Rollers
• Roller Bunk Bracket
• 3 Inch Wide
• Dutton-Lainson

Radial tire has a ply rating of 6 and a 1,820-lb maximum load at 50 psi. The 15" diameter x 5" wide aluminum trailer wheel features a 5 on 4-1/2 bolt pattern and is corrosion resistant.

• 5 on 4-1/2 Inch
• 15 Inch
• Tire with Wheel
• Aluminum Wheels
• Boat Trailer Wheels
• Radial Tire
• 205/75-15
• Load Range C
• Kenda

Rust-resistant assemblies let you install 2 bunk boards on your boat trailer. Swivel brackets enable bunks to tilt when loading a boat. Mounting slots allow for height adjustment. Dimpled surfaces keep brackets from sliding along the trailer frame.

• 3-1/2 Inch Long
• Bunks
• Bunk Bracket
• Swivel Bracket
• 1-3/8 Inch Wide
• 2-1/2 Inch Wide
• 2 Inch Tall
• 8 Inch Tall
• CE Smith

Use this 14-pin connector to connect your trailer to your vehicle to power the trailer's brakes and lights. Built-in magnet creates secure connection with an EZ Connector vehicle-end socket (sold separately). O-rings create a watertight seal.

• 14 Round - Contact
• Trailer Connectors
• Trailer End Connector
• 6 - 10 Feet Long
• EZ Connector

Guide-on posts make it easy to load your boat onto your trailer and back your trailer down the ramp. They attach to the rear of your trailer and extend out of the water, providing visual targets to center the boat between during loading.

• Guides
• Post-Style Guide
• 40 Inch Tall
• CE Smith

2-1/16" x 1-1/16" Rectangle. Waterproof, incandescent trailer light serves as a clearance or side marker light when properly mounted. Durable stainless steel base. Stud mount to trailer. 1-Wire design. P2 Rated.

• 2-1/16L x 1-1/16W Inch
• Submersible Lights
• Clearance Lights
• Red
• Rear Clearance
• Side Marker
• Surface Mount
• Rectangle
• Optronics

These carpeted bunk boards replace your boat trailer's worn-out bunk boards. Each 7' long 2x4 is covered with durable, marine-grade carpet that helps protect the finish on your boat's hull and is easy to clean.

• 84 Inch Long
• Bunks
• Bunk Boards
• 1-3/4 Inch Wide
• 3-3/4 Inch Tall
• CE Smith

• Wire
• 12 Gauge
• Jacketed Wire
• 2 Wire
• Deka

This heavy-duty stand gives you the freedom to mount a winch wherever you choose on your trailer's 2" tongue. Its 14 mounting holes allow you to adjust the height of your winch. Made of hot-dipped galvanized, 12-gauge steel.

• Winch Stand
• 2 Inch Wide
• 30 Inch Tall
• CE Smith

The floating rings on this heavy-duty, ratcheting tie-down let you secure the strap to almost anything. So you can use the strap even if there aren't suitable anchor points for the strap's double J-hooks. 10,000 lbs Max load.

• 1-1/8 - 2 Inch Wide
• 11 - 20 Feet Long
• Trailer
• Truck Bed
• 2001 - 3500 lbs
• Double-J Hooks
• Manual
• 1 Strap
• Erickson

Replace the bow roller assembly on your boat trailer with this durable polyvinyl chloride roller kit. Includes a 4" roller, 2 end bells, and corrosion-resistant hardware. Non-marring material will not leave marks on your boat.

• 8 Inch Long
• 5-1/4 Inch Diameter
• Rollers
• Fits 1/2 Inch Shaft
• Bow Roller
• CE Smith

Corrosion-resistant swivel jack is great for marine use. 8" Wheel turns 360 degrees so you can maneuver in any direction. Weld-on installation with mount and hardware (P9012-00 - sold separately).

• Weld-On
• Sidewind Jack
• Swivel Jack
• Boat Trailer
• With Wheel
• Leveling Jacks
• Tongue Jacks
• 1001 - 2000 lbs
• Steel
• Fulton

These sturdy square U-bolts let you secure 2 double U-bolt bolster brackets or 4 standard bolster or bunk board brackets to your boat trailer's frame. Galvanized steel is durable and corrosion resistant. Hardware included.

• 3-13/16 Inch Long
• 1/2 Inch Diameter
• U-Bolts
• 3-1/16 Inch Wide
• CE Smith

9" Wide x 60" long x 12" tall. These sturdy fenders protect your tandem-axle trailer from road debris. 16-Gauge cold-rolled steel with curved edges is durable. Bolt or weld onto your trailer.

• For Tandem-Axle Trailers
• Steel
• No Step
• 14 Inch Wheels
• 15 Inch Wheels
• 60 Inch Long
• 9 Inch Wide
• etrailer

Keep your small boat centered during the loading process, despite wind and waves, with these bunk-board-style guide-ons. Corrosion-resistant guides are covered with marine-grade carpet and fit trailer frames up to 3" wide x 4-1/4" tall.

• Guides
• Bunk-Style Guide
• CE Smith

9" Wide x 65" long x 15" tall. These sturdy teardrop fenders protect your tandem-axle trailer from road debris. 16-Gauge, cold-rolled steel is durable. Bolt or weld onto your trailer.

• For Tandem-Axle Trailers
• Steel
• No Step
• 14 Inch Wheels
• 15 Inch Wheels
• 65 Inch Long
• 9 Inch Wide
• etrailer

Keep your boat's bow away from your winch and in line with it while you are trailering. The bracket accepts any 3" to 4" bow roller or Y-stop. 11-Gauge pre-galvanized steel can be painted to match your trailer.

• Winch Stand
• Roller Bracket
• 13-3/16 Inch Tall
• CE Smith

9" Wide x 68" long x 17" tall. These sturdy teardrop fenders protect your tandem axle trailer from road debris. 16-Gauge, cold-rolled steel is durable. Bolt or weld onto your trailer.

• For Tandem-Axle Trailers
• Steel
• No Step
• 15 Inch Wheels
• 16 Inch Wheels
• 68 Inch Long
• 9 Inch Wide
• etrailer

Replace worn carpet on your boat trailer's bunks and help protect your boat's finish with this durable, weather-resistant carpet. Marine-grade polyester won't trap in moisture. Resists mold and mildew.

• 216 Inch Long
• Bunks
• Trailer Bunk Carpet
• 18 Inch Wide
• CE Smith

Want brake adjustments that go like clockwork? These brakes automatically adjust as you tow so you don't have to crawl around on the ground to do it manually. 10" x 2-1/4" Assemblies fit 14" to 15" wheels. Made in the USA.

• 3500 lbs Axle
• 10 x 2-1/4 Inch Drum
• Electric Drum Brakes
• 14 Inch Wheel
• 14-1/2 Inch Wheel
• 15 Inch Wheel
• Standard Grade
• Self Adjust
• Dexter

D-L roller bunks provide a quick, easy and inexpensive way to upgrade bunk style trailers to rollers. Attaches directly to vertically mounted 2" x 4" bunk board; mounting bracket, or optional roller bunk bracket (sold separately).

• Bunks
• Rollers
• Roller Bunk
• Dutton-Lainson